Graco 24Y472 ProXChange Pump

Swap a worn pump in minutes with the OEM Graco 24Y472 ProXChange Pump—restore pressure and finish quality without a service visit.

Quick-swap: No special tools required
OEM fit: Genuine Graco replacement module
Fits: Magnum ProX17, ProX19, ProX21, ProLTS 170, ProLTS 190, A60 ProPlus, A80 ProPlus, ProS19 ProPlus, ProS21 ProPlus
When to replace: Pressure loss, pulsation, uneven fan

Retail Price: $119

You save: $28.15 (23.66%)

Our Price: $90.85

Based on 0 reviews

Description

Replacement Pump for Magnum ProX & ProPlus Series (Quick-Swap)

Compatible Machines

Magnum ProX17 (Stand/Cart)
Magnum ProX19 (Stand/Cart)
Magnum ProX21 (Stand/Cart)
Magnum ProLTS 170
Magnum ProLTS 190
Magnum A60 ProPlus
Magnum A80 ProPlus
Magnum ProS19 ProPlus
Magnum ProS21 ProPlus

Tip: Check your sprayer’s model label/parts list before ordering to ensure the exact pump family match.

About the Graco 24Y472 ProXChange Pump

The Graco 24Y472 ProXChange Pump is an OEM, drop-in pump cartridge for select Magnum/Pro series airless sprayers. It’s designed for on-the-job, no-tools swapping so you can replace a worn pump in minutes and keep spraying with minimal downtime.

Quick swap: ProXChange design allows fast pump replacement with simple steps.
OEM reliability: Genuine Graco assembly for proper fit and performance.
Service saver: Reduce trips to the service center; restore pressure and pattern quickly.
Durable build: Long-lasting piston pump engineered for regular/pro use.

Spec	Detail
Part Number	24Y472 (ProXChange Pump)
UPC	755652300700
Pump Type	Airless piston pump module (ProXChange swap-out cartridge)
Typical Use	Replacement for worn/failed pump to restore pressure, consistency, and finish quality

When to Replace

Loss of pressure or pulsation during spray
Uneven fan pattern after usual maintenance
Excessive wear indicated during routine service

Basic Swap Overview

Relieve pressure and unplug the sprayer.
Follow the ProXChange steps (front plate up, release/rotate, remove old pump).
Install the new 24Y472 pump, secure, prime, and test spray.

Frequently Asked Questions

It fits the models listed above (e.g., ProX17, ProX19, ProX21, ProLTS 170/190, and specific ProPlus models). Always verify your exact model/version and pump family in the sprayer’s manual or parts list.

No. The ProXChange system is designed for a quick, no-tools swap. Follow the safety/pressure-relief steps in your manual before starting.

Confirm the inlet strainer is clean, suction tube is sealed, and prime/pressure settings are correct. Prime into a waste bucket until a steady stream appears, then switch to spray mode and test.

Yes—24Y472 is a genuine Graco OEM ProXChange pump module for the models listed.

This pump is not intended for entry-level Magnum models such as X5/X7, handheld units, or non-ProX/ProPlus families. When in doubt, match your current pump part number or consult the sprayer manual.