Graco 15B182 Wire Jumper – Product Details & Compatibility
Compatible Machines
The Graco 15B182 Wire Jumper is used in Graco electric sprayers with control boards that require configurable jumper connections.
- Graco Ultra Max series sprayers (control board wiring)
- Graco PC‑board equipped sprayers where jumper routing defines configuration
- Graco spray systems that use internal jumpers for different voltage or circuit settings
Product Overview
The Graco 15B182 Wire Jumper is a short, flexible electrical component used to bridge circuit connections on Graco control boards. It is installed on PC boards to configure signal flow, power paths, or operational modes based on the sprayer’s design or model.
Key Features
- OEM jumper wire for control electronics
- Allows customization of board wiring and configuration
- Compact and flexible for tight board layouts
- Designed to meet Graco’s electrical and safety standards
Technical Specifications
| Part Number | 15B182 |
| Description | Wire jumper for control board configuration |
| Function | Bridges electrical paths on PC board for proper operation |
| Installed In | Graco control boxes / circuit board assemblies |
Usage Notes
- Disconnect power before installing or removing the jumper.
- Use the wiring diagram or service manual to place the jumper correctly.
- Bundle and secure loose jumper wires to avoid contact with hot or high-voltage components.
- Check continuity after installation to confirm the connection.
Frequently Asked Questions
This jumper wire connects specific paths on the control board, enabling certain electrical configurations required by the sprayer’s circuit.
You might use a generic wire of similar gauge, but the Graco 15B182 ensures correct length, insulation, and reliability as specified by the original design.
Replace the jumper if it is frayed, broken, or damaged, or if you are reconfiguring the control board for a different wiring setup.
