Graco 164862 PTFE V Packing
$27.50
Available to Order
PTFE vee packing for Graco displacement pump 223842 (30:1 President). Restores sealing to reduce rod leakage and maintain consistent spray pressure.
- Part #: 164862
- Location: Fluid-section packing stack
- Material: PTFE for chemical resistance and low friction
- Fits: Displacement Pump 223842 / 30:1 President pump
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Overview & Compatibility Details
Compatible Machines
This part is used in the following Graco pump assemblies / machines. Always verify your pump model before ordering.
- Graco 30:1 President Pump (with displacement pump 223842)
- Graco Displacement Pump 223842 (Severe-Duty / Stainless Fluid Section)
What this part is
The Graco 164862 PTFE V Packing is a precision sealing element used inside the displacement pump’s fluid section to maintain high-pressure sealing performance and chemical resistance in professional airless equipment.
Key Specifications
| Attribute | Detail |
|---|---|
| Part Number | 164862 (164-862) |
| Type | V-shaped packing (vee packing) for pump seal stack |
| Material | PTFE (Teflon) for excellent wear and chemical resistance |
| Primary Location | Displacement pump fluid section (packing stack) |
| Known Pump Assembly | Graco 223842 (used on 30:1 President pump) |
| Typical Use | Restores sealing; helps maintain pressure and reduce leakage at the rod |
Fitment Guidance
- Match your displacement pump number. If your unit uses pump 223842, this packing is applicable.
- Model updates can change internal packings; confirm via your sprayer’s parts manual or existing packing number.
- Replace packings when you notice fluid seepage at the rod or difficulty maintaining operating pressure.
Frequently Asked Questions
Check your displacement pump part number. If your pump is 223842 (commonly found on the 30:1 President), this packing applies. When in doubt, consult your model’s parts manual or contact support with your exact sprayer model and serial.
Install vee packings in the correct orientation as shown in the pump manual, lubricate per spec, and tighten the packing nut to the recommended torque. After reassembly, prime the unit and verify there is no leakage at the rod.
Replace when you notice persistent drips at the throat, reduced pressure, rough pump stroke, or after a major abrasive/solvent-heavy job. Regular inspection during maintenance helps prevent downtime.
PTFE offers broad chemical resistance and low friction, making it suitable for many solvent-borne and waterborne coatings. Verify chemical compatibility with your specific materials before use.
No reviews yet. Be the first to review this product!
