There are certain problems that we face a lot when working with sprayers out of which tip clogs are the most occurring and the most annoying. When you begin working you are in a flow and these clogs become irritating when they disturb the consistency of both work and spray. 

No problem comes without a solution so Spray Tip clogs also has a solution. Well, not just one bit quite a few that we will get to know about below. So let's begin with that without any further ado.

Find the Cause

While using a spray machine for paint sometimes you feel disturbed patterns and discontinuous flow. There may be many reasons behind it but one of the main reasons is clogging in the tip. This happens because of using unstained paint that contains any debris or hard particles. 

Moreover, if you do not clean the spray tip regularly after every use the leftover paint will build up and block the tip and affect the spray flow and coverage. 

Shake or Invert

If you will find any clog in the orifice of the spray tip then you must clean it and remove it as soon as possible. But make sure not to use abrupt methods because they can damage the tip of the sprayer machine.

For this, you can shake the tip to and fro and also invert the sprayer. This will help you in removing the dried paint without damaging the parts of the spray tip. 

Thorough Cleaning

If you want to extend the lifespan of your sprayer machine then you should schedule a proper cleaning routine for it. While cleaning, remove all the working parts and soak them in water for some time. This will be helpful in removing the dried paint. 

After that wash all the parts and you can use a soft bristle brush to gently remove any leftover paint. Also, you can use any kind of solvent to deeply clean the sprayer tip. Then dry them completely. 

Too Clogs Prevention

As we all know, prevention is better than cure. That's why to protect your machine from blockage you should cut down all the possible ways that can initiate buildup and clogging in the different parts of the sprayer machine. 

Staining and regular cleaning are the best ways to prevent blockage of leftover paint. Number one if you use paint that contains dirt or debris it will stick to the tip. Number two if you leave paint in the tip for a longer time and will not clean it, then it will choke the spray tip. 

Conclusive Remarks 

The tip is the most functioning part of the sprayer machine. If you are familiar with such devices then you must know that clogging is a big problem. So to make your machine work properly you should percent clog and choke in the Spray Tip. 

Additionally, to buy authentic, long-lasting, and reliable products for your sprayer machine you should give Sprayer And Parts a try. Because they will never disappoint you with their high-standard products.