Graco 1595 Standard Hi-Boy Tip and Guard Parts List

Ultimate Guide: Graco 1595 Standard Hi‑Boy Tip & Guard Parts

For professional painters, contractors, and rental fleets, Graco 1595 Standard Hi‑Boy remains a workhorse renowned for its robust construction, consistent output, and service-friendly parts architecture. When you rely on this sprayer, understanding its tip assembly, guard components, and essential accessories is key to maintaining top-tier performance and minimizing downtime.

What Makes the 1595 Hi‑Boy So Resilient?

The 1595 is part of Graco’s Ultra Max II electric sprayer lineup, featuring hardened steel pumps rated for up to 3,300 psi and delivering around 1.35 gpm. Its Hi‑Boy cart design provides mobility and stability, while easy access to major components makes field maintenance straightforward. Over years of use, pros consistently highlight its durability and repairability.

Tip & Guard Components: Why They Matter

1. Spray Tip

Installed on the spray gun’s end, the tip defines flow rate and spray pattern. Guards are tailored to accommodate various tip sizes FFLP for fine finishing or RAC‑X for broad coverage. Tips over 0.039″ are supported by the 1595, optimizing for thick coatings.

2. Tip Guard

This essential safety accessory shields against accidental contact and fluid leaks. Different guards fit FFLP (fine finish) or LP/RAC-X tips. Ensure correct guard alignment and tighten to the recommended torque to avoid leaks or tip blowouts.

3. Prime/Spray Valve

Also known as the “dump valve,” this component directs fluid toward your gun or drains it. Proper sealing ensures smooth switching and pressure control. OEM valves help avoid leaks and maintain efficiency.

4. Fluid Strainer & Gun Filter

Integral to debris prevention, the fluid strainer (inside the pump manifold) and gun filter (e.g., 60 mesh) protect internal components and the spray tip from clogging.

Choosing Genuine OEM Parts

Using authentic Graco components is vital. Original parts like tips, guards, valve kits, filters, O‑rings are designed to specific tolerances and tested for performance. Pros agree: the repairability and long life of Graco equipment are why they keep going back. Plus, parts are widely available via SprayersandParts.com.

Maintenance & Troubleshooting

• Inspect tip and guard daily: Replace worn tips and cracked guards to prevent spray variations and fluid leaks.
• Clean filters after each job: Clogged gun filters lead to pressure drops; pump strainers help avoid costly repairs.
• Torque specs matter: Over-tightening guard nuts risks damage; follow Graco’s manual specs.
• Prime/Spray valve upkeep: Faulty valves can disrupt flow. Ensure seals and seats are clean and replaced during rebuilds.

Enhancing Your Setup: Tips & Accessories

• Fine-Finish (FFLP) tips and blue guards for smooth cabinet and trim finishes.
• Large RAC-X tips + standard guard for high-volume coatings.
• Prime/spray valve kits, O-ring packs, rebuild kits to minimize downtime.
• Filters (60/100/200 mesh) to protect tip and prevent finish defects.

Summary

When it comes to the Graco 1595 Standard Hi‑Boy, many professionals affirm its dependability, repairability, and long life even under heavy commercial use. That level of field-proven reliability depends heavily on maintaining the tip, guard, prime/spray valve, filters, and valves in top condition.

Investing in genuine OEM parts especially for areas prone to wear ensures that your sprayer continues delivering factory-level performance. Equip your toolbox with spare tips, guards, filters, and O‑rings to stay productive and profitable.