Please wait while we process your order...

Product successfully added to your cart.
Cart Image

Quantity in Cart: 1

Continue Shopping Shopping Cart
Item removed from Cart
X
 
×

sprayersandparts Logo

Product Image

Graco 054739 Tube Pvc Rd

The Graco 054739 Tube PVC RD is a durable OEM replacement tube made from high-quality PVC with a 0.625" OD, ideal for internal fluid routing in select Graco airless sprayers.

  • Part Number: 054739
  • Material: PVC (Round)
  • Outer Diameter: 0.625" (5/8")
  • Use: Internal fluid/return lines
  • Compatibility: Confirm with sprayer parts manual

$7.4
0
Based on 0 reviews
5 ★
0%
4 ★
0%
3 ★
0%
2 ★
0%
1 ★
0%

Graco 054739 Tube PVC RD — OEM Round PVC Tube (0.625" OD)

Compatible Machines

Official model-specific compatibility is not published by Graco for this generic tubing part.

Use your sprayer’s parts manual to confirm fit wherever a 0.625" OD PVC round tube is specified (internal fluid/siphon/return routing). If your manual lists 054739, this is the correct OEM replacement.

  • Check your exact model’s exploded parts diagram for part 054739.
  • Match required outside diameter (0.625"), material (PVC), and round profile.
  • Verify length/end-connection requirements for your unit’s routing.

Product Summary

The Graco 054739 Tube PVC RD is a genuine OEM round PVC tube designed for internal fluid handling on select Graco airless sprayers. Its 0.625" OD sizing supports leak-resistant routing in manifolds and fluid lines when the parts manual specifies this tube.

Key Specifications

Part Number 054739
Description Tube, PVC, RD (round profile)
Outside Diameter (OD) 0.625" (5/8")
Material PVC (polyvinyl chloride)
Typical Use Internal fluid routing (manifold/tubing harness/return paths) on airless sprayers where 0.625" OD PVC tube is specified
Fitment Model-specific. Confirm with your sprayer’s parts manual.

Why Choose Genuine OEM

  • Correct 0.625" OD and material spec for listed assemblies
  • Optimized internal routing for consistent fluid delivery
  • OEM quality for reliable sealing when properly installed

Installation Tips

  1. Power down and follow pressure relief procedure per your manual.
  2. Measure the required run; cut cleanly with a sharp tubing cutter (deburr ends).
  3. Match orientation and end connections per the diagram; avoid kinks and tight bends.
  4. After installation, perform a leak check at low pressure before full operation.

Frequently Asked Questions

Compatibility is model-specific. Check your sprayer’s parts manual or exploded diagram—if it lists 054739 (or “Tube, PVC, RD, 0.625" OD”), it will fit that location. If your manual lists a different OD or material, use the specified part instead.

Confirm the outside diameter (0.625"), material (PVC), required length, and the type of end connection (clamp, barb, push-fit). Match your manual’s specification and routing path.

PVC is widely used but not universal. Verify chemical compatibility with your coatings/cleaners. For aggressive solvents, your manual may specify alternative materials—always follow the OEM specification.

Yes—cut to the length shown in your parts diagram. Use a clean, square cut and avoid crushing the tube. Re-install clamps/fittings exactly as specified to prevent leaks.

Internal routing tubes typically see low to moderate system pressures compared to the high-pressure hose. Always operate within your sprayer’s ratings and use the tube only where the manual specifies 054739. If unsure, consult a Graco-authorized service center.

Payment Method   Payment Method   Payment Method   Payment Method 

ADDRESS