Graco 15D087 Grommet
$9.10
In Stock
The Graco 15D087 Grommet provides a secure seal for control box wiring and sensors, protecting internal components from dust and vibration.
- Seals control box wiring
- Reduces vibration damage
- OEM-quality replacement part
- Easy to install
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Graco 15D087 Grommet Overview
The Graco 15D087 Grommet is a precision‑designed elastomer sealing component used in the control box of Graco airless sprayer systems. It secures wiring or transducer stems, provides vibration dampening, and maintains a reliable environmental seal to protect internal electronics.
Specifications
| Part Number | 15D087 |
|---|---|
| Type | Control Box Grommet / Seal |
| Material | Flexible rubber / elastomer |
| Location | Control box wiring or transducer port |
| Purpose | Seal and vibration isolation for components |
| Typical Use | Installed in Graco spraying equipment control modules |
Key Features
- Secure sealing: Maintains proper barrier against dust and moisture.
- Vibration damping: Helps reduce wear on wiring and sensors.
- OEM quality: Specifically engineered to fit Graco control box designs.
- Simple replacement: Low‑cost part that supports longer system life.
Installation Notes
- Disconnect power and open the control box housing.
- Remove the old grommet carefully without damaging adjacent wires.
- Insert the new 15D087 grommet into the mounting hole until fully seated.
- Carefully route the wire or sensor stem through the grommet center.
- Close the control box and verify there is no gap around the grommet.
Frequently Asked Questions
It seals and supports wiring/sensor pathways, preventing contamination and vibration damage.
If the old grommet is intact and undamaged, reuse is possible. Replacing ensures the best seal and longevity.
Replace it whenever signs of cracking, hardening, or seal failure appear during maintenance.
No reviews yet. Be the first to review this product!
