Compatibility – Graco 101194 Screw Set
Place this section at the top so customers can quickly verify fit before buying.
- Graco T2 2:1 Ratio Transfer Pump — appears in the T2 pump parts list as a 10-32 × 0.25 in socket-head set screw.
- Graco T3 Transfer Pump (incl. Series B) — listed in the T3 pump parts breakdown as a set screw used in the lower assembly.
- ProConnect CS Pump Lower — referenced in the ProConnect CS pump-lower parts manual as a set screw component.
What is the Graco 101194 Screw Set?
A factory set screw for Graco equipment. It’s a socket-head set screw (thread size 10-32, length 0.25 in (≈6 mm)) commonly used in T2/T3 Transfer Pumps and related pump-lower assemblies.
Key Specifications
| Part Number | 101194 |
| Type | Socket-head set screw |
| Thread Size | 10-32 UNF |
| Length | 0.25 in (≈6 mm) |
| Typical Use | Secures collars/shafts within Graco transfer pump and pump-lower assemblies |
| Quantity | Sold individually (1 pc) |
Where It Appears in Assemblies
| Assembly | Callout / Note |
| T2 2:1 Ratio Transfer Pump | Listed as 101194, set screw 10-32 × 0.25 in; secures components near retaining collar in the pump lower. |
| T3 Transfer Pump (Series B) | Appears as 101194 in the lower assembly parts list; used with shaft/retaining components. |
| ProConnect CS Pump Lower | Shown as 101194 in the parts breakdown; used to locate/lock a mating component. |
Fitment & Install Notes
- Confirm your model’s manual lists 101194 explicitly before ordering.
- Inspect the mating bore/shaft; clean threads and apply thread-locker only if specified by the manual.
- Tighten to the manufacturer torque for your assembly (refer to service instructions).
Frequently Asked Questions
No. It’s used where a 10-32 × 0.25 in socket-head set screw is specified—commonly in T2/T3 transfer pumps and some pump-lower assemblies. Always check the parts diagram for your exact model.
Thread is 10-32 UNF and length is 0.25 in (≈6 mm). Head style is socket-head set screw.
Only if your manual specifies it. Many assemblies install the set screw clean and torque to spec; some procedures call for medium thread-locker. Follow the service procedure for your model.
Open your unit’s parts manual and search for 101194. If present, it’s the correct replacement. If you only see thread/size, confirm it matches 10-32 × 0.25 in socket-head set screw.
