Compatible Machines
Graco does not publish a definitive model-by-model list for Graco 101498 Tee Pipe Fitting. Use the checks below to confirm fit before ordering.
- Machines whose parts manual lists “Fitting, Tee, Pipe” with part number 101498.
- Graco airless & fluid systems that require a 3-port tee in the paint/fluid circuit (e.g., pump outlet/manifold branches).
- Units using the same thread type/size as this fitting (verify against your machine’s parts diagram or existing fitting).
Overview
The Graco 101498 Tee Pipe Fitting is an OEM, T-shaped junction used to split or combine fluid flow within Graco spray and fluid-handling systems. It sits inline with hoses/manifolds to create a branch for accessories, returns, gauges, or secondary lines.
Key Specs
| OEM / Brand | Graco |
| Part Number | 101498 |
| Type | Fitting, Tee, Pipe (3 ports) |
| Typical Use | Branching paint/fluid lines on pumps, manifolds, and hose assemblies |
| Thread / Size | Not published in open sources — match to your machine’s parts list or existing fitting |
| System Compatibility | Applicable across many Graco airless & fluid systems where a tee is specified |
How to Confirm Fit
- Check your machine’s parts manual for item “Fitting, Tee, Pipe” part 101498.
- Measure/verify the thread type & size against your current tee fitting.
- Confirm the tee is installed at the same circuit location (e.g., pump outlet / manifold branch).
Installation & Maintenance Tips
- Depressurize system and relieve fluid pressure before service.
- Use a sealant or tape compatible with coating/solvent in use; avoid contaminating the flow path.
- Tighten to spec; avoid over-torquing which can crack fittings or distort threads.
- After installation, pressure-test for leaks at operating pressure.
Frequently Asked Questions
Graco does not list a universal model map for 101498. Confirm by checking your parts manual for this exact part number or by matching the thread type/size and installation location in your fluid circuit.
Open sources do not publish the exact rating/material for 101498. Use it only where the fitting size and rating meet or exceed your system’s operating pressure. If in doubt, consult the machine’s parts manual or contact support with your model and serial.
Yes, if the thread type/size and pressure rating match and there’s adequate clearance. Always verify sealing surfaces and test for leaks after installation.
