Precision Silver Flat Tip – 0.029″ Orifice (Graco 163829)
Compatible Machines
Fits Graco airless sprayers that use a flat tip guard and can support a 0.029″ orifice at operating pressure. Verify your gun/guard type before purchase.
- Ultra Max II 795
- Ultra Max II 1095
- Ultra Max II 1595
- Mark V HD 3-in-1
- Mark X HD 3-in-1
- GMAX II 3900
- GH 230 HD 3-in-1
- GH 300 HD 3-in-1
- Magnum X5
- Magnum X7
- ProX17
- ProX19
- ProX21
Product Overview
Graco 163829 Silver Flat Tip (829) is a precision, flat-fan airless spray tip from the Silver series. It is engineered for consistent coverage and fine, uniform finishes on architectural and industrial coatings when the sprayer and material match the required flow.
Technical Specifications
| Tip Code | 163829 (Silver Flat Tip “829”) |
| Orifice Size | 0.029″ (≈ 0.737 mm) |
| Fan Width (approx.) | 16–18″ at recommended standoff and pressure |
| Max Working Pressure | 5,000 psi (≈ 345 bar) — tip series rating |
| Guard / Gun Interface | Requires a Flat Tip Guard compatible with Silver Flat Tips |
| Series | Silver (163- series) precision flat tips |
| Typical Use | Architectural & industrial coatings where a wide, even flat-fan is desired |
Key Features
- Uniform flat-fan pattern for efficient coverage of large surfaces.
- 0.029″ orifice supports higher-build coatings when sprayer output matches.
- High-pressure capable (up to 5,000 psi tip rating).
- Precision-cut tip edges from the Silver series for consistent finish quality.
Setup & Best Practices
- Confirm your spray gun uses a Flat Tip Guard designed for Silver Flat Tips.
- Match material viscosity and sprayer flow/pressure to the 0.029″ orifice.
- Maintain recommended stand-off distance to achieve the listed 16–18″ fan.
- Filter and strain materials; keep tip/gasket clean for optimal pattern.
Frequently Asked Questions
The 163829 Silver Flat Tip is intended for a Flat Tip Guard, not a RAC reversible guard. Ensure your gun is fitted with the correct flat-tip guard designed for Silver Flat Tips.
Heavier architectural and some industrial coatings can be suitable when the sprayer supplies adequate flow and pressure. Always follow coating manufacturer recommendations and test pattern on scrap before production.
Expect an approximate 16–18″ fan at the recommended stand-off and pressure. Actual width may vary with pressure, distance, and material viscosity.
