Graco 17J866 Front Cover
$81.85
$89.25
Save 8%
In Stock
The Graco 17J866 Front Cover is a genuine OEM replacement that protects the control area and wiring of your stand-mounted sprayer. Designed for perfect fit and long-lasting durability.
- Fits ProX17 Stand, ProX19 Stand, and ProLTS 170 Stand models
- Includes pump locking cover, wire cover, jumper cable, and screws
- Easy to install with factory-aligned mounting points
- Ensures clean, safe, and organized front assembly
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Overview
The Graco 17J866 Front Cover is a genuine OEM front housing/face cover kit for select Magnum/ProLTS TrueAirless Stand sprayers. It protects the control area and wiring while keeping service access quick and clean.
Compatible Machines
- ProX17 — Stand (Magnum TrueAirless)
- ProX19 — Stand (Magnum TrueAirless)
- ProLTS 170 — Stand
Why choose the 17J866 Front Cover?
- Direct-fit OEM kit engineered for the models above—no drilling or modification.
- Protects internals (switch/wiring/control area) from jobsite dust and debris.
- Service-friendly design for fast removal and routine maintenance.
- Includes hardware for a complete, hassle-free install (see table below).
What’s Included in 17J866 Kit
| Component | Part Number | Notes |
|---|---|---|
| Pump Locking Cover | 17F233 | Locks/finishes pump access opening |
| Wire Cover | 17F262 | Protects internal wiring run |
| PC Jumper Cable | 128551 | Factory-spec jumper |
| Mounting Screws (Torx/Pan) | 115478 | Set of fasteners |
| Hex Washer Head Screw | 118444 | Additional hardware as required |
Fitment & Identification Tips
- Designed specifically for Stand versions of ProX17, ProX19, and ProLTS 170.
- Match your model sticker (rear/side of frame) with the list above before ordering.
- If your sprayer is a cart configuration or a different series, this cover may not apply.
Installation Notes
- Disconnect power and relieve pressure per Graco instructions.
- Remove existing front cover/fasteners; retain any clips if reused.
- Route wiring neatly, install the wire cover (17F262) and jumper (128551) if included/required.
- Position the new 17J866 Front Cover, install screws (115478, 118444) and tighten evenly.
- Fit the pump locking cover (17F233), verify switch operation and reassemble per manual.
Frequently Asked Questions
No—this kit is specified for the Stand versions of ProX17, ProX19, and ProLTS 170. Cart models use different shrouds/frames; confirm your exact configuration before purchase.
Yes, 17J866 is a Graco OEM kit and includes the specified hardware/components for the listed machines.
The kit typically includes 17F233 pump locking cover, 17F262 wire cover, 128551 PC jumper cable, and mounting screws (115478, 118444)—see the table above.
Check the model label on your unit. If it reads ProX17 Stand, ProX19 Stand, or ProLTS 170 Stand, this kit applies. If you have a cart version or a different series, contact support for the correct shroud/cover.
Disconnect power, relieve pressure, route wiring cleanly under the wire cover, and tighten fasteners evenly. Wipe the cover with a damp cloth after dusty jobs to maintain visibility and airflow around controls.
No reviews yet. Be the first to review this product!
