Graco 238438 Q Strainer 60 Mesh Multi-Pack
$18.50
In Stock
The Graco 238438 Q Strainer 60 Mesh Multi-Pack helps keep your sprayer running clean and efficient by filtering debris before it reaches the spray tip. Ideal for professional painters using long Easy-Out filters.
- Part Number: 238438
- Type: Long Easy-Out Q Strainer
- Mesh Size: 60 mesh (medium-coarse filtration)
- Purpose: Prevents clogs and pump wear
- Fits: Ultra 395/495/595, Ultra 695, EM 390/490/590, EH 333/433
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Compatible Machines
This filter fits Graco sprayers that use the Easy-Out “long” manifold filter (11 mm bore / #7 cap). Confirm your housing before ordering.
- Ultra 395 / 495 / 595 (Hi-Boy & Lo-Boy)
- Ultra 695 (1999–2000)
- Ultra Plus 1000 / 1500
- EM 390 / EM 490 / EM 590
- EH 333 / EH 433
- Other Graco cart/stand units using the long Easy-Out (#7) filter cap
About This Part
Graco 238438 Q Strainer 60 Mesh Multi-Pack is a long-style Easy-Out manifold filter that helps protect your pump and spray tip by screening debris before it reaches the hose and gun. The 60 mesh rating targets medium-to-heavier materials (common interior/exterior latex, primers, block-fillers), reducing clogs and improving finish quality.
| Graco Part # | 238438 |
|---|---|
| Type | Easy-Out long manifold Q Strainer (11 mm bore / #7 cap family) |
| Mesh / Filtration | 60 mesh (captures larger particles typical of latex & primers) |
| Primary Use | Reduce tip clogs, protect pump/wear parts, stabilize spray fan |
| Compatibility Note | Not for Magnum/DIY units that use the short (#5) Easy-Out filter. Check your manifold housing length. |
| Pack | Multi-Pack (carry spares and swap as needed on the job) |
When to Choose 60 Mesh
- Production interior/exterior latex paints and most primers
- Block-filler and other higher-solids coatings within your sprayer’s rating
- Common tip sizes around .015–.029 (manufacturer & coating dependent)
Install & Care
- Relieve pressure and lock the gun trigger.
- Unscrew the Easy-Out cap from the manifold block and remove the old strainer.
- Insert the new 238438 (long) strainer, then reinstall and snug the cap.
- Prime briefly; monitor pressure and pattern. Clean or replace when flow drops or pattern falters.
Frequently Asked Questions
Long. It fits manifolds that use the #7 (11 mm bore) long cap. If your unit uses the short (#5) cap, this is not the correct filter.
Most interior/exterior latex paints, many primers, and heavier-bodied coatings that benefit from coarser screening. Use finer meshes for thin lacquers or stains as recommended by the coating manufacturer.
Replace when you notice reduced flow, frequent tip clogs, or visible damage to the screen. Many pros carry spares and swap daily on heavy-solids jobs, then clean used strainers for reuse if the screen remains intact.
Typically no. Magnum/DIY units commonly use the short (#5) Easy-Out filter family. Verify your manual or manifold cap length before ordering.
Keep multiple meshes on hand (e.g., 60 and 100). Use the coarser strainer for heavier coats and switch to finer mesh for thin finishes to balance flow and filtration.
No reviews yet. Be the first to review this product!
