Graco 256972 Complete Fluid Section
$424.20
$505.00
Save 16%
In Stock
The Graco 256972 Complete Fluid Section restores full pumping performance for select FinishPro sprayers. Perfect for quick, reliable replacement of the entire lower assembly.
- OEM part for FinishPro 290 & FinishPro II 295
- Includes full pump lower assembly
- Ensures consistent pressure & finish quality
- Quick swap – minimal downtime
Quantity
Genuine OEM Part
Fast Shipping (Order by 1 PM CST)
Easy Returns
Compatible Machines
- Graco FinishPro 290 (Air-Assisted Airless)
- Graco FinishPro II 295 (Air-Assisted Airless)
Product Overview
The Graco 256972 Complete Fluid Section (also referred to as an Endurance Pump Lower) is a genuine OEM lower-pump assembly designed for quick replacement on select FinishPro 290 and FinishPro II 295 sprayers. Replacing the entire fluid section restores prime, pressure, and sealing performance without rebuilding individual wear parts.
| Part # | Official Name | Sprayer Families | Purpose |
|---|---|---|---|
| 256972 | Complete Fluid Section / Endurance Pump Lower | FinishPro 290, FinishPro II 295 | Restore pumping performance by replacing the entire lower assembly in one swap. |
Key Benefits
- OEM fit & reliability for compatible FinishPro units.
- Minimizes downtime versus piecemeal seal/packing repairs.
- Consistent pressure & finish quality after installation.
When to Replace
- Chronic prime/pressure loss or pulsation under load.
- Visible leaks from the lower section or persistent pack-out.
- Excessive hours on original pump lower with declining performance.
Install Tips (General)
- Relieve pressure, lock trigger, and disconnect power/air as applicable.
- Flush with appropriate solvent and clean fluid path before removal.
- Swap the Complete Fluid Section per your model’s service manual.
- Prime with compatible solvent, then coating; check for leaks and set pressure.
Frequently Asked Questions
It is a Complete Fluid Section (pump lower assembly). Small external hardware may be reused from your unit per the service manual. Always inspect seats, balls, and seals after installation and replace ancillary items if worn.
Check your sprayer’s exact model designation and serial range. This part fits FinishPro 290 and FinishPro II 295. If your plate or manual lists a different lower-pump part number, use that specified part instead.
Yes—replacing a worn lower assembly typically restores prime, pressure stability, and atomization, assuming the motor, air-assist, gun, and tip are in good condition and properly sized for the coating.
Only standard hand tools and PPE are typically required. Follow the service manual for torque specs and safety steps (pressure relief, lock-out, flushing). If unsure, have a qualified technician perform the swap.
Use coatings recommended for your FinishPro 290 / FinishPro II 295 (fine-finish lacquers, enamels, sealers, etc.). Always filter/strain coatings and confirm tip size and pressure per the coating TDS.
No reviews yet. Be the first to review this product!
