Graco 102410 Cap Head Screw

The Graco 102410 Cap Head Screw is a genuine OEM fastener designed for precise fit and secure assembly within Graco industrial systems.

Used in E-Flo UniDrum Supply Systems and VRM Metering Modules
Ensures reliable joint strength and alignment
Manufactured to exact OEM standards
Recommended for verified model assemblies only

$9.05

Based on 0 reviews

Description

Graco 102410 — Cap Head Screw (Overview & Compatibility)

Compatible Machines

Based on Graco parts lists/manuals, the Graco 102410 Screw, Cap Head is used in the following Graco industrial assemblies. Always verify against your unit’s parts manual.

E-Flo UniDrum Supply System (E-Flo drum supply assemblies/variants)
VRM (Volumetric Ratio Meter) metering modules/systems

Product Summary

The Graco 102410 is a factory fastener designated as SCREW, CAP HEAD. It secures critical sub-assemblies within select Graco industrial coating and metering equipment. Use only genuine Graco hardware to maintain fit, clamp load, and safety compliance.

Key Specifications

Graco Part Number	102410
Description (Graco)	SCREW, CAP HEAD (socket/cap head machine fastener)
Typical Application	Structural/assembly fastener inside Graco industrial equipment (e.g., E-Flo UniDrum, VRM modules)
Thread/Size	Per equipment parts manual (not publicly specified)
Material/Finish	Per equipment parts manual (use OEM part to ensure spec and torque)
Replaces/Cross-ref	None listed by OEM at time of writing

Why Choose Genuine 102410

OEM Fit: Ensures proper engagement and clamp load for assemblies.
Reliability: Spec-matched hardware for vibration and duty cycles in industrial use.
Service Simplicity: Drop-in replacement referenced by the exact Graco PN.

Installation Notes

Follow torque values specified in your equipment’s service manual.
Replace any damaged fasteners rather than re-using.
Use thread treatment (e.g., threadlocker) only if the OEM procedure specifies it.

Frequently Asked Questions

It is primarily listed in industrial assemblies such as E-Flo UniDrum and VRM modules—not typical consumer handheld sprayers. Confirm in your model’s parts list before purchase.

The exact dimensions and torque are provided in the OEM service or parts manual for your specific machine. Use those values to ensure safe installation.

No official cross-reference is published. For safety and warranty alignment, use genuine Graco hardware that matches the specified part number.

Locate your model and serial on the equipment tag, then check the latest Graco parts list/exploded diagram. If 102410 appears for your serial range, it is the correct fastener.

Replace in a cross pattern where applicable, bring fasteners to snug first, then torque to spec. Re-check torque after initial run-in if the OEM procedure calls for it.