Compatibility & Fitment Overview
Compatible Machines
- Check your Graco parts book/exploded diagram for 054138.
- Match tube size/spec (.245" OD, urethane) with the line shown in your schematic.
- Verify application (primer/return/transfer tube) and routing/length before purchase.
Graco 054138 – Tube Urethane Rnd .245 OD
The Graco 054138 is a urethane round tube with an outer diameter of 0.245", commonly used in Graco fluid-handling paths (e.g., return/transfer/primer lines) where flexibility, abrasion resistance, and chemical compatibility are required.
Key Specifications
| Part Number | 054138 |
| Description | Tube Urethane Rnd .245 OD |
| Outer Diameter (OD) | 0.245 inch |
| Material | Urethane (flexible, durable, abrasion-resistant) |
| Typical Use | Fluid return / transfer / primer lines in select Graco systems |
| Notes | Confirm length, routing, and any fittings per machine schematic before ordering. |
Why Choose This Tube
- Durable urethane for long service life in fluid paths.
- Flexible for tight routing and reduced kinking risk (when installed correctly).
- .245" OD helps match specific Graco line specs where indicated in parts manuals.
- Suitable for a range of compatible coatings and fluids (verify chemical compatibility).
How to Verify Fitment
- Open your machine’s parts manual/exploded diagram and look for 054138.
- Match OD .245" and material: urethane with the line specified.
- Confirm the tube’s function (return/transfer/primer) and the required length.
- Check compatibility with the coatings/solvents you run.
- Still unsure? Share your model & serial with us—our team will cross-check the parts list.
Frequently Asked Questions
Graco does not publish a universal model list for this tube. Confirm by checking your machine’s parts manual for 054138. If the manual specifies this exact part number, it will fit your unit’s intended line and location.
The tube is .245" OD and made of urethane for flexibility and durability in fluid handling paths.
Always verify chemical compatibility of urethane with your specific material. Some strong solvents may require alternative materials. When in doubt, consult the coating’s data sheet or contact us.
Measure the existing tube from fitting to fitting along the installed route. Add a small allowance for bends and service loops. Follow the machine schematic to avoid sharp kinks or pinch points.
Use the part number and specifications shown in your manual. If it differs from 054138 or from .245" OD urethane, select the exact part specified to maintain performance and safety.
